Hello,
I have a 6 foot Paasache airbrush hose and also a Passache moisture that I bought at the same time. I cannot figure out how to install the moisture trap on my air hose. How do you conect it to the hose? Where is a good place to put it in the hose (closer to the compressor or the airbrush)? Any other information that you may think I should know about installing the moisture trap would be greatly appreciated. Thank you.
Return to Beginners Category Menu
You need to cut the hose and I believe it's 18" down from the connection for best results. From there you screw the hose into the adapters and your ready to go.
Also the little screw goes on the bottom hose.