I mounted my first bobcat and the foam rock ledge finally came in. I'm not sure the best way to attatch the leg wires to the ledge. It's a standing bobcat. The ledge has a plywood back that goes against the wall on most of the backside. The rock is about 12 inches high, 30 inches long and sticks out from the wall about 10 inches. I thought about drilling a hole down from the top, then a hole from the back that would intersect the first hole. I don't think I can fish the wire through easily though. Maybe just drill one hole from the top, stick the wire in and glue? Any help would be great. p.s. I did check the archives without much luck.
Return to Beginners Category Menu
Heath if the rock is hollow fiberglass or resin, you could cut a hole in the plywood back big enough for your hand to bend the wire over and attach under. Or if it's a foam filled rock, drill holes then use bondo, 2 part epoxy, or just squirt some hot glue in and around the hole and hold it down a few seconds til it takes hold. It'll stay put.