What is the best way or how do you attach these to the wall mounts that I see listed in the WASCO Catalog. Got 5 done and need to fasten to plaques Thanks
Return to Beginners Category Menu
We just screw ours on using 1 1/2 to 2 inch screws.
Kim Collins
The absolute best way is to go to the hardware store and buy the 3" X 1/8" screw/bolt with collapsible wing nut that you use to hang stuff in sheetrock. You'll drill a 1/4" hole just below the brain cavity in the center of the skull. Put the skull on the plaque so you can judge where the hole should be, and drill a hole through the plaque. On the back of the plaque countersink the hole, then put the bolt up through the plaque into the cavity and put on the wingnut and tighten it down. If bolt is to long cut it with a hack saw. Works the best.. I put and old shirt or something under the skull when I'm test fitting it to prevent any scratching of the plaque... good luck
Thanks Guys the wing nut Idea is what I will go with. "Damn I feel Dumb"
Ken Edwards made a category for folks like you. It can be found over there to the left under that orange SEARCH icon. Your question, at last count is number 78. That means 78 other people have already asked that same question and 77 of them didn't look in the right place either.
N/T