keep getting slippage

Submitted by jay on 5/10/05 at 4:49 PM. ( ) 205.200.45.6

I can't figure it out, I keep on getting hair slippage! I'm salting lots, resalting, picklingas per directions with oxilic acid. Shaving the hide down and using liqua tan. still keep getting hair slipping on bears especially, Can anyone give me ideas as to why this is happening and what I can do? I purchased stop slip and applied to areas with the problems but it does not seem to do anything! Help please! Thank you in advance!

Return to Gamehead Taxidermy Category Menu


if

This response submitted by lee on 5/10/05 at 5:38 PM. ( ) 68.238.141.71

if you are following directions, and keeping the ph right, you have probally had bad hides. no matter how well you do everything, if you start with a bad hide you will get bad results.


shaving too thin?

This response submitted by drake on 5/10/05 at 6:09 PM. ( ) 64.136.27.226

Are you possibly shaving the hide too thin? It is easily done on bears!


stop-rot

This response submitted by Terry on 5/10/05 at 9:37 PM. ( ) 69.149.226.193

I finally bought some and I think it works great. Apply as your skinning and watch how good it works.


Degrease

This response submitted by Frank E Kotula on 5/11/05 at 6:14 AM. ( basswtrout@msn.com ) 141.158.149.151

What I'm reading here is that all is well but your not degreasing. If you have fat left on the hide the liqua-tan may find it hard to get through it.
Also what is your Ph during the pickling process?


Krowtann

This response submitted by dave h on 5/11/05 at 12:26 PM. ( ) 68.249.226.167

Use it, it works and eliminates all that screwing around.


Return to Gamehead Taxidermy Category Menu