Banteng bosses

I would build them using a picture to give a good representation of what they actually looked like when it was taken, do not use pictures of other Banteng....the bosses are never the same on different animals. . I have used sculp all or fiberglass resin mixed to a very thick consistency using Hi Fiber. Sculp all will give you a bit more working time and produce a better product. Use the fiberglass mixture to use on soft boss Cape Buffalo, smooth the surface with a chip brush lightly moistened with Acetone or Lacquer Thinner. WEAR PROTECTIVE MASK AND EYEWEARD WITH THE FIBERGLASS RESIN, and don't forget the catalyst.

 

I was always too lazy. I covered them with sculptall and then used a pieces of Berber and high/low carpet to press into the sculptal.

 

I would use the fiberglass putty without a doubt. I would probably use clay to make the primary buildup causing less use of the putty............and use a short chip brush to bring out the texture..........don't forget to use the catalyst and use acetone or lacquer thinner to make a smoother surface with the brush. The acetone and fiberglass putty will cause the putty not stick to the brush