/ Register

  1. Welcome to Taxidermy.net, Guest!
    We have put together a brief tutorial to help you with the site, click here to access it.

reattaching a split elk skull cap

Discussion in 'Deer and Gameheads' started by Lone Spur, Jan 15, 2017.

  1. Jan 15, 2017 #1
    Lone Spur

    Lone Spur Member

    45
    0
    I'm looking for some ideas on how to put a split elk skull back together. I did a search and just not finding to many ways on how to do this. if you Guys/Gals have methods that you use could you please pass on some of them on to me. Thank you
     
  3. Jan 15, 2017 #2
    3bears

    3bears Well-Known Member

    6,410
    2,433
    MN
    Drill corresponding holes on both sides of split and tie wire the two sides together, fill cavity with reinforced bondo. I put epoxy on each side and hold it in place till is kicks prior to wiring.
     

  5. Jan 16, 2017 #3
    Lifesigns Taxidermy

    Lifesigns Taxidermy New Member

    145
    3
    Washington State
    Pretty much same method here. I drill a few extra holes and set antlers upside down. cover holes with duct tape and pour bondo, self levels and like the extra support in the pre-drilled holes.
     
  6. Jan 16, 2017 #4
    wayne70

    wayne70 Member

    511
    1
    Illinois
    x3 probably the fasted and easiest as above
     
  7. Jan 16, 2017 #5
    WLELTD

    WLELTD Active Member

    760
    132
    X4 but I think the epoxy holds way better than bondo,health reasons alone should steer all taxidermist away from this stuff.
     
  8. Jan 16, 2017 #6
    Lone Spur

    Lone Spur Member

    45
    0
    Thank you for the ideas.